Default status after power-on

Green

Steady on

The AP is just powered on and the software is not started yet.

Software startup status

Green

Steady on after blinking once

After the system is reset and starts uploading the software, the indicator blinks green once. Until the software is uploaded and started, the indicator remains steady green.

Running status

Green

Blinking once every 2s (0.5 Hz)

1. The system is running properly, the Ethernet connection is normal, and STAs are associated with the AP.
2. The system enters the Uboot CLI.

Blinking once every 5s (0.2 Hz)

The system is running properly, the Ethernet connection is normal, and no STA is associated with the AP. The system is in low power consumption state (no data is being transmitted and the EEE function takes effect).

Alarm

Green

Blinking once every 0.25s (4 Hz)

1. The software is being upgraded.
2. After the software is uploaded and started, the AP working in Fit AP mode enters the registration state and has not registered successfully with the AC yet. 
3. The AP registration fails (the CAPWAP link is disconnected).

Fault

Red

Steady on

A fault that affects services has occurred. The fault cannot be automatically rectified and must be rectified manually (the fault can be a DRAM detection failure or system software loading failure).

Blinking once every 0.25s (4 Hz)

A fault that affects services has occurred. The fault cannot be automatically rectified and must be rectified manually (the fault can be an Ethernet interface error， such as a PHY error, or a radio interface detection failure caused by a PCI-e interface error or a baseband chip error).