The AP5030DN is a cost-effective 802.11ac access point (AP) that provides a rate of up to 1.75 Gbit/s. It is well-designed with rich features and especially applicable to high-density scenarios, including enterprise offices, airports and stations, digital trains, and stadiums, delivering ubiquitous access services.
3x3 MIMO (three spatial streams)
Maximum rate: 1.75 Gbit/s
Built-in antenna
20 dBm
-
Appearance
Interfaces
1. Console interface.
2. GE1: a 10/100/1000M interface, which connects to the wired Ethernet.
3. GE0/PoE: a 10/100/1000M interface, which connects to the wired Ethernet and supports PoE power supply.
4. Power input interface: 12 V DC
5. Security slot: connects to a security lock and protects the AP against theft.
6. Default button: restores factory settings if you hold down the button more than 3s.
LED Indicators
Information Type
Color
Status
Description
Default status after power-on
Green
Steady on
The AP is just powered on and the software is not started yet.
Software startup status
Green
Steady on after blinking once
After the system is reset and starts uploading the software, the indicator blinks green once. Until the software is uploaded and started, the indicator remains steady green.
Running status
Green
Blinking once every 2s (0.5 Hz)
1. The system is running properly, the Ethernet connection is normal, and STAs are associated with the AP.
2. The system enters the Uboot CLI.Blinking once every 5s (0.2 Hz)
The system is running properly, the Ethernet connection is normal, and no STA is associated with the AP. The system is in low power consumption state (no data is being transmitted and the EEE function takes effect).
Alarm
Green
Blinking once every 0.25s (4 Hz)
1. The software is being upgraded.
2. After the software is uploaded and started, the AP working in Fit AP mode enters the registration state and has not registered successfully with the AC yet.
3. The AP registration fails (the CAPWAP link is disconnected).Fault
Red
Steady on
A fault that affects services has occurred. The fault cannot be automatically rectified and must be rectified manually (the fault can be a DRAM detection failure or system software loading failure).
Blinking once every 0.25s (4 Hz)
A fault that affects services has occurred. The fault cannot be automatically rectified and must be rectified manually (the fault can be an Ethernet interface error, such as a PHY error, or a radio interface detection failure caused by a PCI-e interface error or a baseband chip error).
AP5030DN Access Point
- Brands Huawei
- Product Code: AP5030DN
- Availability: In Stock
-
$377.78
- Ex Tax: $377.78