Click Here For New Access Controller Products Page
Introduction
Huawei AC6005 is a small box wireless access controller that provides wired and wireless access services. It delivers flexible campus and office networking solutions for small-to medium-sized enterprises and branches. Huawei offers two AC6005 models: AC6005-8 and AC6005-8-PWR with PoE support.
• 4 Gbit/s forwarding capability
• 128 access points
• 2K users
• 1+1 hot backup
Characteristics
Abundant Port Types
- 8 GE Service ports
- One RJ45 maintenance serial port
- One USB Maintenance port.
Large Capacity, High Performance, Integrated Design
- Large forwarding capacity: the AC has 8 GE ports, and provides 4 Gbit/s forwarding capacity.
- PoE: The AC supports the PoE function and can provide the maximum power on 8 ports. This PoE capability can provide power to APs and other powered devices (PDs) connected to the AC unit.
Carrier-Class Reliability
- Port backup based on the Link Aggregation Control Protocol (LACP) or Multiple Spanning Tree Protocol (MSTP).
- The AC supports 1+1 hot backup.
Easy-to-Install and Easy-to-Maintain
- The AC6005 dimensions (width x depth x height) are 320 mm × 233.6 mm × 43.6 mm and the AC6005 can be installed on a desk or in a standard IEC cabinet(19 inch).
- The built-in web system of AC allows local GUI-based management.
- The AC can be managed by the eSight that provides various northbound interfaces.
- The AC supports the intra-board temperature probe, which monitors the operating environment of the AC in real time.
Energy Conservation
- Low noise fans that can adjust the speed automatically are used, thus reducing noises in the system and power consumption of fans.
- The chip switches to the power saving mode when no connected device is detected on a service interface, that is, the interface is idle.
- It uses highly-integrated and energy-saving chips produced through advanced processing techniques. With the help of the intelligent device management system, the chips not only improve system performance but also greatly reduce power consumption of the entire system.
Physical Specifications
Item | Description | |
---|---|---|
Dimensions (width x depth x height) | 320 mm×233.6 mm×43.6 mm | |
Maximum power consumption | AC6005-8-PWR: 163.6 W (device power consumption: 39.6 W, PoE: 124 W) AC6005-8: 25.6 W |
|
Weight | AC6005-8-PWR: 2.30 kg AC6005-8: 2.05 kg |
|
Operating temperature | -5ºC to +50ºC | |
Relative humidity | 5% RH to 95% RH, non-condensing | |
Operating altitude | -60 m to 5000 m | |
AC input voltage | Rated voltage | 100 V AC to 240 V AC, 50/60 Hz |
Voltage range | 90 V AC to 264 V AC, 47 Hz to 63 Hz |
System Configuration
Item | Specifications |
---|---|
Processor | Dominant frequency: 1 GHz |
Switching capacity | 20 Gbit/s |
Forwarding capacity | 4 Gbit/s |
DDR memory | 2 GB |
Flash memory | 2 GB (SD card) |
Protocol and Management Capabilities
Parameter | Specifications |
---|---|
Number of managed APs | 128 |
Number of access users | Entire device: 2K Single AP: a maximum of 256 (depending on the AP model) |
Number of MAC address entries | 4K |
Number of VLANs | 4K |
Number of routing entries | 4K |
Number of multicast forwarding entries | 4K |
Number of DHCP IP address pools | 4K |
Number of local users | 128 IP address pools, each of which contains a maximum of 16K IP addresses |
Number of ACLs | 1000 |
Number of ESSIDs | 4K |
User group management | 1K |
Wireless Networking Capabilities
Feature | Specifications |
---|---|
Networking between APs and ACs | APs and ACs can be connected through a Layer 2 or Layer 3 network. APs can be directly connected to an AC. APs are deployed on a private network, while ACs are deployed on the public network to implement NAT traversal. ACs can be used for Layer 2 bridge forwarding or Layer 3 routing. |
Forwarding mode | Direct forwarding (distributed forwarding or local forwarding) Tunnel forwarding (centralized forwarding) Centralized authentication and distributed forwarding Before users are authenticated, tunnel forwarding is used. After users are authenticated, local forwarding is used. |
Wireless networking mode | WDS bridging: Point-to-point (P2P) wireless bridging Point-to-multipoint (P2MP) wireless bridging Automatic topology detection and loop prevention (STP) Wireless mesh network: Access authentication for mesh devices Mesh routing algorithm Go-online without configuration |
AC discovery |
An AP can obtain the device's IP address in any of the following ways: Static configuration |
CAPWAP tunnel |
Centralized CAPWAP |
Active and standby ACs |
Enables and disables the switchback function. |
AC6005 Access Controller AP Resource License(8 AP)
- Brands Huawei
- Product Code: L-AC6005-8AP
- Availability: In Stock
-
$380.88
- Ex Tax: $380.88
Related Products
Tags: ac6005, access, controller, resource, license(8, ap), huawei, wlan